Common faults and failure causes of garden lights Garden lights are a type of outdoor lighting, usually refers to outdoor road lighting below 6 meters, the main components are: light source, lamps, light poles, flanges, foundation embedded Part 5 is composed of garden lights, which are also called landscape garden lights because of their diversity, aesthetics, landscaping and decorative environment. It is mainly used for outdoor lighting in urban slow lanes, narrow lanes, residential quarters, tourist attractions, public places such as parks and plazas, which can prolong the time of people's outdoor activities and improve the safety of property.
There are two types of common faults: one is a high-impedance fault; the other is a low-impedance fault. The so-called high-resistance fault, that is, the cable is blown, the meter measures the resistance, or the insulation decreases between the phases or the ground, but there is a certain resistance; the so-called low-resistance fault, that is, the wire is short-circuited or completely shorted to the ground, the current Increase, the power transmission has a trip phenomenon. These two types of faults and their frequent occurrence pose a threat to the normal use of garden lights. Therefore, we must pay full attention to the reasons and countermeasures.
cause of issue
1. Poor construction quality
The proportion of failures caused by construction quality is large. Main performances: First, the depth of the cable trench is not enough, the sand-covered bricks are not constructed according to the standard; the second is that the production and installation of the aisle tubes do not meet the requirements, the two ends are not made according to the standard; the third is when paving the cable The fourth pre-buried pipe is not constructed according to the standard requirements, mainly because the pre-buried pipe is too thin, plus a certain degree of camber, it is quite difficult to wear the cable, and there is a "dead bend" at the bottom of the foundation; The wire nose crimping and insulation wrap are not thick enough, and after a long period of operation, the phases are short-circuited.
2, the material is not off
Judging from the fault conditions handled in recent years, there are also many factors in the low quality of materials. The main performance is: the wire contains less aluminum, the wire is harder, and the insulation layer is thin. This situation has been more common in recent years.
3, the quality of supporting projects is not too hard
The courtyard light cable is usually laid on the sidewalk. The construction quality of the sidewalk is poor, the ground sinks, and the cable is deformed by force, resulting in cable armoring. In particular, the northeastern region is in a cold zone, and the arrival of winter makes the cable and the soil form a whole. Once the ground subsides, it will be strained at the bottom of the garden lamp base, and when the rainwater is too much in summer, it will be blown at the base root.
4, the design is not reasonable
On the one hand, it is overloaded. With the continuous development of urban construction, the garden lights are also constantly extended. When the garden lights are newly built, which circuit lights are close to each other, which circuit is received, and in recent years, the advertising industry has developed rapidly, and the advertising load is also connected to the courtyard. On the lamp, the load of the garden lamp is too large, the cable is overheated, the wire nose is overheated, the insulation is lowered, and the grounding is short-circuited; on the other hand, the lamp post is designed only considering the condition of the lamp post, ignoring the space of the cable head, After the cable head is wrapped, most of the doors are not closed, sometimes the cable length is not enough, and the joint production does not meet the requirements, which is also a factor causing the failure.
- Led tunnel light, led light bar and other lighting classification and LED light use and maintenance methods
- Widely used in LED street lamps, mining lamps and other led lights and incandescent lamps, energy-saving lamps
- The application prospect of solar led street light
- LED point light source for exterior wall decoration experts
- Performance characteristics of LED floodlight manufacturers
- Led floodlight manufacturers' dimming technology and future development
- Led point light source selection skills
- Comparison of Led solar street light and traditional led street light
- What is the difference between led high power wall washer and LED line light?
- What is the difference between Magnolia and Chinese lanterns?
- LED solar garden lights and outdoor waterproof landscape lights
- LED street light pole height and spacing design method
- The technical principle of LED wall washer